Linde Electric Stacking Truck Type 379: L10 SN from R03977, L12 SN from R03974 Operating Instructions (User Manual)
Original Illustrated Factory Operating Instructions (User Manual) for Linde Electric Stacking Truck Type 379.
Original factory manuals for Linde Forklift Trucks, contains high quality images, circuit diagrams and instructions to help you to operate and repair your truck
L10 SN from R03977
L12 SN from R03974
Format: PDF,56 Pages
Plates and labels
General view L 10 – L 12
Controls L10 – L12
Combined hour meter
Discharge limiter indicator
Operation / Daily checks and maintenance prior to operation
Advice for initial use
Checks before initial operation
Daily checks before use
Check the Forward/Reverse and raise/lower controls
Check the safety braking
Check the L12 automatic braking
Check emergency isolator operation
Check operation of horn
Check the battery state of charge
Open the battery cover with vertical outlet
Connect/disconnect the battery
Charge the battery with the integrated charger
Faults during charging
Remove the mains power supply cord
Charger electrical data
Special case of gelled batteries
Recharging the battery with anexternal charger
Check the condition of cables, terminals and battery contact
Check level of electrolyte and water supplement
Check the electrolyte gravity
Remove/replace the battery
Chang the battery with the help of a hoist.
Operation L10 – L12
Instructions for use
Marking the travel direction
Direction of travel reversal
Emergency stop button.
Operating the truck on ramps.
Starting on a slope.
Braking by reversing the direction of motion.
L.B.C. (Linde Brake Control) automatic braking.
Use of the mast
Use of the mast.
Chassis lifting controls for L10 – L12.
Tiller lifting controls for L10 – L12 .
Tiller lifting controls for L10Premier.
Capacities L10 – L12.
Reading the load diagram L10 – L12.
Picking up a load on the ground .
Transporting a load.
Putting down the load on the ground.
Stacking a load.
Picking up a load at a height.
Before leaving the truck.
Slinging, towing and removing the mast
Slinging the truck.
Raising the order picker.
Removing the mast.
Transporting and storing the truck.
Work on the lifting mast.
Simplex lifting mast.
Safety device for the Simplex lifting mast .
Standard lifting mast.
Safety device for the Standard lifting mast.
Duplex lifting mast.
Safety device for the Duplex lifting mast .
Checks and maintenance work after the first 50 hours of service
Schedule of maintenance operations.
Maintenance as required
Cleaning the truck
Opening the front cover
Releasing the flexible cover to access reduction gear unit and motor
Cleaning the battery and battery compartment
Battery in sealed case
Maintenance every 500 hours
Checking hydraulic circuit sealing
Checking hydraulic oil level
Replacing traction motor brushes
Cleaning the electrical plate and checking the electrical connections
Cleaning and checking contact wear
Checking the condition of cables, terminals and battery contact
Checking the incorporated charger
Checking the electrolyte level and density
Adjusting the height of the stabiliser wheel
Checking the condition and fixing of the mast and chains
Checking the mast protections
Adjusting the length of mast chains
Check the condition and fixing of wheels
Checking and controlling the brake controls
Checking the transmission belt status
Cleaning and greasing the mast and chains
Maintenance every 1000 hours
Cleaning the hydraulic filters and breather
Replacing pump motor brushes
Checking the mechanical fixing of components
Maintenance every 2000 hours
Replacing the hydraulic oil
Recommended lubricants/ Technical data
You must log in and be a buyer of this download to submit a review.